HotRC XT60 Lipo Balanced Parallel Charging Board

  • Sale
  • Regular price $18.00
Tax included. Shipping calculated at checkout.

XT60 Lipo Battery Charging Plate 2-6S Parallel Balanced Charging Board With XT60 Adaptor Connector


  • Thicken PCB copper foil and with the 40A Fuse, which allow security using 40A charging current.
  • Built-in short circuit protection and prevent Short Circuit, 20Z of thick copper foil sustainable resistance to flow 40A.
  • XT60 parallel charging board used for simultaneously charging multiple lithium batteries,Accelerates battery charging,the same time more battery charges and saving charging time(including B6 B8 B6ac and other balance types)
  • This ParaBoard can be used for batteries with JST-XH type balance plug (the most popular type in the market)
  • It can support combined use for three parallel charging boards (it means you can charge eighteen batteries which have the same characters at the same time).


  • Balance Output Cable: 22AWG silicon cable
  • Main Output Cable: 14AWG high quality silicon cable
  • Connector: XT60 ; T-Plug
  • Max current: 40A
  • Cell: 2~6S
  • Battery: 6 packs (same discharge state andamp; cell count)
  • Voltage: 0~22.2VDC
  • Size: 143x86x19mm


  • 1x  2-6s Parallel charging board with XT60 Adaptor
  • 1x Connect Cable
  • 1x User Manual
  • Batteries should NEVER be left unattended while charging.
  • Be absolutely sure that the Lithium Polymer charger settings are correct for the battery pack being charged – both voltage and current settings.
  • Lithium Polymer must be CHARGED and STORED in a fire-safe container like a Lipo Sack.
  • Do not charge batteries near flammable items or liquids.
  • Keep a dry fire extinguisher nearby or a large bucket of dry sand, which is a cheap and effective extinguisher.
  • Never charge inside an automobile even when parked.
  • KEEP BATTERIES AWAY from children and pets at ALL times.
  • Never discharge below 3.5V per cell as it may cause permanent damage and void warranty
  • Battery may explode if damaged or disposed of in fire
  • Never leave batteries inside a car on a hot day or any other place where temperature may exceed 140F / 60C.
  • Although environmentally friendly, lithium polymer cells must be FULLY discharged before disposal. Use a resistor setup (light bulbs, for example) to accomplish this, to avoid the possibility of a short-induced fire after disposal.
  • Immediately discharge damaged batteries at 1/2 C rate and dispose
  • Do not put the loose cells in a pocket, bag, or drawer where they could short-circuit against other items, or the battery tabs could be pressed against each other.
  • Take care that the cells are not punctured, especially by metallic objects like hobby knives.
  • If the electrolyte in the cells should get on your skin, thoroughly wash with soap and water. If in the eyes, rinse thoroughly with cool water. Immediately seek medical attention for this, or for burns.