SPECIFICATIONS:
- ESP8285, SX1280/1281
- Antenna connector: IPEX MHF 1/U.FL
- 5x PWM outputs
- RF Frequency: 2.4GHz (2400~2480MHz)
- Telemetry power: 12dbm
- Receiver protocol: PWM or CRSF
- Input voltage: +5V DC @ “+” pad
- PCB size: 17mm x 14mm
- Weight: 1.1g with antenna
- Default firmware version: ExpressLRS v2.0
FIRMWARE:
- DIY_2400_RX_PWMP, PWM receiver via 1~5 PWM outputs
- HappyModel_EP_2400_RX, CRSF Serial receiver via TX and RX
- Firmware update via UART or WIFI
BIND PROCEDURE:
- Supply power to the EPW5 RX, wait until the Green LED on the RX is off, immediately turn off the power, and then repeat again the above steps. When the RX is powered on for the third time, the Green LED light will start to double-flash, which means that the RX enters the binding mode
- Get into menu of ELRS.LUA V2.0 version from your radio transmitter and then press BIND, the Green LED on the RX module will getting to be solid if bind successfully.
Receiver LED status:
- LED flash fast means in WIFI hotspot mode, you can connect the WIFI of the RX and upgrade firmware of the RX via visit 10.0.0
- LED flash slowly means no signal connection from the TX module
- LED solid means bind successful or Connection established
- LED double-flash means in bind mode
INCLUDES:
- 1x Happymodel EPW5 2.4GHz PWM RX
- 1x Happymodel 2.4GHz Antenna - Short
- 1x Happymodel 2.4GHz Antenna - Long
- 2x Happymodel Stickers
- 3x 2.54m 6-Pin